Accessories

Raptor Adapter

The Raptor Adapter is a thread conversion piece which takes the proprietary base-end TPI of the Raptor series, and converts it to the “industry standard” 1.375 x 24 TPI. 

  • 0.200”

  • 0.9oz

  • 17-4 PH

Standard End Cap

Maximize your suppression potential. Enhance the performance of the Raptor across multiple bores using the accessory end caps. Offered in 5.56, 7.62, .338, .375 and 6.5.

  • 0.6oz

  • 1.625”

  • TITANIUM

Flash Hider end cap

Offered in both Titanium and Stainless, the Flash Hider End Cap will nearly eliminate the flash generated from the combusting gases of each shot. Available in 5.56, 7.62, .338 and .375.

  • 0.55”

  • 0.95oz

  • 1.625”

TITANIUM

  • 0.55”

  • 1.6oz

  • 1.625”

17-4 PH

Raptor Flush Mount

When a Reflex mount cannot be utilized, flush mounts are available to accommodate a wide variety of firearm styles.  Available in 1/2 x 28, 5/8 x 24, 3/4 x 24.  Custom threaded mounts are available at no additional cost, but do come at an increased lead time.  Fits the AB Suppressor Raptor Series and CZ-USA Ti Reflex.

  • 1.6oz

  • 1.625”

  • TITANIUM

Thread Adapter

A thread conversion piece that converts a 1/2 x 28 thread pitch to 5/8 x 24, allowing the 7.62 suppressor to work with other hosts. Each adapter is machined with all mating surfaces in one process, keeping the suppressor perfectly in-line with the bore.

  • 17-4 PH

  • 1.4oz

6-pin tool

End cap & flush mount removal/installation tool for Raptor series. Can also be used to torque Sabre onto/off of host firearm’s barrel.  Fits the AB Raptor Series, Sabre, CZ-USA Ti Reflex and S2.

Little bird tool

Provided with every Little Bird & MELB purchase, this tool is used to install, adjust and remove each of the four baffles. Marked with factory-recommended depth settings but allows for custom tuning.